Cooking in the kitchen can be a challenge when your overhead lighting only casts your shadow on your work desk, and cabinets above the countertop can block the light even more. Installing lighting under the cabinet can decorate the work area, eliminating the mystery of cooking. Instead of having a switch for each light fixture, connect the fixtures together so that when you flip the switch, all the fixtures under the cabinet turn on.
1
Turn off the light switch under the cabinet. Run a non-contact voltage sensor along the fixtures or bring it to the wall switch. The sensor warns you about the presence of electricity by beeping and flashing.
2
Squeeze the lens cap with your hands to remove it from each light fixture. Turn the light bulbs to remove them.
3
Locate the screws that secure the cover to the wiring connections. Remove the screws to remove the lid.
4
Find one of the circles etched into the metal at the end of the fixture under the cabinet. Look at the end closest to the next fixture. Press a small screwdriver against the circle and gently tap the screwdriver with a hammer to dislodge the circle from the fixture.
5
Remove the lock nut from the two-screw non-metallic cable clamp. Insert the threaded end of the clamp into the hole in the fixture, with the cable clamp screws positioned on the outside of the fixture. Screw the lock nut onto the thread to secure the clamp. Repeat the steps to install the cable clamp on the nearest end of the next closest fixture, and so on for each fixture.
6
Drill holes on the sides of two adjacent cabinets, if possible, along the bottom edge. If the ledge is too narrow, drill a hole in the bottom of the cabinets near the back wall. Drill a hole in the adjacent cabinet walls at the back. Use a 1/2-inch spatula crown and a cordless drill to make the holes.
7
Pass a piece of non-metallic 12/2 electrical cable through the cable clamp of the first fixture, through the holes in the cabinet, and into the next clamp. Repeat for each device if necessary. Each device must have at least 15 cm of cable.
8
Tighten the screws on the cable clips to secure the wires. Attach the cable to the bottom of the cabinets using plastic non-metallic staples.
9
Insert the ends of the cable into the NM wire and cable stripper. Squeeze the handles on the stripping device to remove at least 10 cm of the outer non-metallic shell to expose the wires inside. Use a wire stripper to remove approximately 1.9 cm of insulation from each wire.
10
Align all the black wires inside the fixtures. Screw the red insulated connector onto the end of the wires. Make the same connections with all the white wires and all the ground wires.
11
Replace the covers for each fixture above the wire connections and secure them with the screws that you removed earlier. Install the light bulbs and replace the lens caps. Turn on the automatic light switch under the countertop. A well-planned entry into the betting world often determines the overall enjoyment and success level. Megapari has prepared an appealing environment for players who appreciate quality and variety. To gain the strongest possible foundation, activating a premium code is highly recommended. Located in the middle of this beneficial offer is the megapari promo code today it while registering and depositing to claim up to $100 in welcome funds. This boost allows for more flexible participation in both popular leagues and emerging betting categories.
